D I Y - MARBLE HEADBOARD

Hey guys!

Just a quick one from me today, but I'm going to share with you how I made my boring, basic Ikea headboard into a super #extra marble master piece!
It cost me just over £5, and took around half hour to complete. It makes my bed look super expensive and luxurious!

Apologies for the horrible wallpaper, it doesn't really fit the beautiful aesthetic of the DIY project. We're moving out so there isn't much point in me redecorating just yet.

--------------------------------------


Here's what you need;

A head board (Duh... but you can do this with anything!)
Marble contact paper ; Here's the one I used (Marble Contact Paper)
Scissors
Hard Card/Sturdy Plastic
*Optional sticky tape*
---------------------------------------



First thing you'll need to do is grab your headboard, this took me a while as it was screwed into the bed frame. Finally I managed to pull it off and placed it on my mattress to get started.



This is the contact paper I ordered from Amazon. The link is above. It's the perfect width for my headboard and 2 meters long so I have plenty left for future projects!
The contact paper is really simple to use. Once opened, there is a piece of sticky plastic holding the roll in place. I used this to secure the roll to one side of the paper to stop it rolling back up. Make sure you attach it to the back of the headboard around 2inchs in. As the back of the headboard won't be seen we don't need to cover the whole thing.



When securing the paper, you need to ensure that it is lined up with the bottom of the headboard. We don't need to over lap the bottom as we need to be able to put it back into place. Again, the bottom is not seen. Ensure to leave the top of the paper handing over the edge ready to stick down to the top of the headboard in the final steps.


If you need some extra help to ensure it stays straight when you're putting it down, use sticky tape to hold sections in place. Try and use one that wont leave a sticky residue. If it does leave a sticky mark though, don't worry; you should be able to wipe it down after the material is pretty durable.

Once you're all lined up, you are ready to go! It's super easy. Just peel back the backing. Ensure to do this inch by inch. I found it's the easiest way to minimize air bubbles. Now take your bit of plastic. Whatever you'd like to use, I used a Blackhead Peel Off Mask box at first, but it wasn't hard enough so I used my GAME rewards card in the end instead. 

 
Use the card to push towards the area where you are pulling away the sticky back plastic. This step helps to reduce the air bubbles and make the headboard look more authentic rather than cheap. Once the paper is down it's kinda hard to work with. So do try and go little bit, by little bit to get rid of those bubbles. Just to save yourself some hard work after.
 


Now, I missed a photo here but it's pretty straight forward. Now that the made base is down. You'll hopefully have left over contact paper at the top of the board. Before you think about it! Do not try and stick it like you'd wrap a Christmas present. You'll end up with creases visible at the top and we don't want that. Instead, use the scissors to cut a small line where the two corners meet. Fold the side stripe down, and then cover with the top area. This will mask the corner and give you a beautiful clean edge. 





And that's the end! Once you're happy with the result, attach it back to your bed and lounge in your new wonderful marble masterpiece!!
*adding your Stitch stuffed toy is optional*



Stephanie - xoxo